| 加工定制 | 是 |
|---|---|
| 货号 | 1050473 |
| 种类 | 传声器(咪头) |
| 类型 | 驻极体传声器 |
| 材质 | 铜 |
| 规格尺寸 | 10*5.0（mm） |
| 声道数 | 多声道 |
| 灵敏度 | -36~-60dB |
| 频率响应 | 100~16,000Hz |
| 输出阻抗 | 2.2KΩ |
| 主要下游平台 | 速卖通,亚马逊,wish,ebay,LAZADA,独立站 |
| 主要销售地区 | 欧洲,北美,东南亚,东北亚,中东,非洲 |
| 是否跨境货源 | 是 |
| 品牌 | 领音者 |
| 型号 | BU1050L-473 |
承認書 SPECIFICATION FOR APPROVAL
东莞市音领袖电子有限公司 工厂地址：东莞市长安镇增田恒泰路4号2楼 TEL：400-1140041 FAX：+86-769-85643930 E-mail：voicelerder@126.com
| ||||||||||||||||||||||||
PRODUCT SPECIFICATION
TYPE：ECM | PART No：BU1050L-473 | PAGE: 2/8 |
1.Scope The specifications should be applied to electret condenser microphone of BU4015L-473
2.Storage And Judgement Conditions
3.Specifications Test Conditions：VS=1.5V，RL=680Ω,Temp=20±2°C, R.H=60±5%????
4.Frequency Response
| |||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||
PRODUCT SPECIFICATION
TYPE：ECM | PART No：BU1050L-473 | PAGE: 3/8 |
5.APPEARANCE & DIMENSIONS
|
PRODUCT SPECIFICATION
TYPE：ECM | PART No：BU1050L-473 | PAGE: 4/8 |
6.Test Circuit
7.Test Setup Drawing
|
PRODUCT SPECIFICATION
TYPE：ECM | PART No：BU1050L-473 | PAGE:5/8 |
8. Reliability Test
All tests should be done after 2 hours of conditioning at 20℃,R.H65% ,while the sensitivity is to be within ±3dB from the initial sensitivity after the following experiments.
8.1 High Temperature Test High temperature:+85℃ Duration:72 hours
8.2 Low Temperature Test Low temperature: -40℃ Duration: 72 hours
8.3 Temperature Cycle Test (See in Fig.1) Low temperature: -25℃ High temperature: +85℃ Changeover time: 24hours Duration: 24hours Cycle: 32
8.4 Statical Humidity Test Temperature: +60℃ Relative humidity: 90～95% Duration: 72hours
|
PRODUCT SPECIFICATION
TYPE：ECM | PART No：BU1050L-473 | PAGE:6/8 |
8.5 Vibration Test Amplitude : 1.52mm Duration: 1minutes /plane Freq.range: 10～55 Hz Total time: 2 hours
8.6 Dropping Test Drop a unit unpacked onto a board of 20mm thick. Height: 1.0 m Cycle: 6
8.7 ESD Test The microphone under test must be discharged between each ESD exposure without ground. (contact:±6KV,air:±8KV)There is no interference in operationafter 10 times exposure.
9. Regarding the Soldering operation a. Use 15~ 20W soldering iron and maintain 290℃~310℃ in operation. b. Operators who work in the solder fixture and the soldering iron must be statically groundedunder eachsoldering process. C. Soldering should be accomplished within two seconds at each terminal so as not to be overheated. d . Optimal design for heat sink pad is same as below. |
PRODUCT SPECIFICATION
TYPE：ECM | PART No：BU1050L-473 | PAGE:7/8 |
10. List and Structure of Materials
|
PRODUCT SPECIFICATION
TYPE：ECM | PART No：BU1050L-473 | PAGE:8/8 |
11. HANDLING INSTRUCTION
1、Assembly process a)、After connector and holder are once disassembled , they should not be re-used. b)、Do not touch outer springs directly(except for PCB or proper terminal set at nominal height. c)、Do not give any mechanical shocks to the micphone(e.g. dropping to floor)
2、General information 2-1:This microphone shall not be operated or stored in following environment.
>where liquid(water,solvent and so on)splashes.
>where the air has a high concentration of corrosive gas .
>where is too dusty.
>where temperature changes rapidly.
2-2: Frequency response especially in high frequency region is dependent on the structure of enclosure. Please remove additional acoustic mass or cavity in front of the microphone to the utmost.
2-3:do not put mechanical pressure more than 2 kg to the microphone.
2-4: microphone should not be in state of outgoing packing for a long-term storage.
2-5: all the soldering procedures upon microphone must be complete in a metallic device,the temperature of the soldering irons must be limited as 320℃ and less 3 s ,the operators、the solder fixtures and the soldering irons must be statically grounded under each soldering process. |
产品简介 |
咪头，又称为咪芯 MIC 咪胆 器 拾音器 送话器 话筒 麦克风 等 从工作原理上有分为：碳晶粒咪头 电磁式咪头 电容式咪头 驻极体电容式咪头 压电晶体式咪头 压电陶瓷式咪头 二氧化硅式咪头 SMD贴片式咪头 硅咪 等 |
我们的优势 |
|
产品展示 |
|
产品应用 |
|
一般情况下：划线价格：划线的价格可能是商品的销售指导价或该商品的曾经展示过的销售价等，并非原价，仅供参考。
未划线价格：未划线的价格是商品在中国站上的销售标价，具体的成交价格根据商品参加活动，或因用户使用优惠券等发生变化，最终以订单结算页价格为准。活动预热状态下：划线价格：划线的价格是商品在目前活动预热状态下的销售标价，并非原价，具体的成交价可能因用户使用优惠券等发生变化，最终以订单结算页价格为准。
未划线价格：未划线的价格可能是商品即将参加活动的活动价，仅供参考，具体活动时的成交价可能因用户使用优惠券等发生变化，最终以活动是订单结算页价格为准。*注：前述说明仅当出现价格比较时有效。若商家单独对划线价格进行说明的，以商家的表述为准。